Standard Machining Services continued
Part No.
Anchor Butt Fastener Counterbores
For 5/16″ wide slot profiles the counterbore dia. = .812 x .650 deep. Location is .75 from the end
Example:
(2) EX-1 x 150.0
(2) EM-1
(4) EM-8
(2) EF-61
EM-8
For 1/4″ wide slot profiles the counterbore dia. = .562 x .445 deep. Location is .438 from the end
Example:
(2) EX-11 x 100.0
(2) EM-1
(4) EM-9
(2) 11-243
EM-9
Set Screw Anchor Fastener Counterbore
For 5/16″ wide slot profiles using and EF-49 fastener,
an EM-13 counterbore dia = .625 dia x 1.00 deep
at a distance of 1.312″ from the end of the extrusion.
Example:
EX-65 ; 32.000″ ; EM-13 [F] @ 1.312, 30.688
EM-13
Wire Mesh Cut to Size
Panels any side <= 48.0″
EM-4S
Panels any side > 48.0″
Example:
A. Wire Mesh and Plastic Panels
are sold by the number of square feet
B. To calculate square feet,
multiply the length by width (in inches)
and then divide by 144.
Round up to nearest square foot.
C. Example:
(1) EB-38-1 that is 24″ x 47″
Order:
(8) sq ft EB-38-1 (1) @ 24″ x 47″
(1) EM-4S
EM-4L
Clearance Hole in a Panel EM-3P
For clearance holes drilled into panel material,
include an EM-3P. Please provide a sketch.
Notch in Panel or Mesh EM-4N
For notches in panels or mesh, include
an EM-4N for each notch. Please provide a sketch.
Extrusion Mitre Cuts & Counter Bores
Miter cut per end
EM-6
Counter bore & hardware per end
EM-10
EM-6/Cut Piece
Example
Order:
(2) EX-1 x 36.0
(2) EM-6
(2) EM-10 (times (2) for double slot, i.e. EX-2)
Note: for custom angles, consult the factory.